1
Retaining pin
2
Locking pin
3
Brush adjusting handle
Important
Adjust the brush so that the left and right sides
are even.
Turn the brush adjusting handle to raise the
brush to approximately 6 mm (0.24 in)
[cutting 3 mm (0.12 in)].
Turning the handle to the right (clockwise)
lowers the brush.
Turning the handle to the left
(counterclockwise) raises the brush.
h
rmpe72-004
Adjustment of Brush Operation Height_004
h
Brush height
Re-place the locking pin and retaining pin.
Perform actual work, and gradually adjust
the brushes to the appropriate collection
position.
Check with an adjustment at every half turn.
Start/Stop of Engine
Procedure to Start Engine
Caution
Do not start the engine in a building with
insufficient ventilation.
Caution
Before starting the engine, make sure that
there are no other people or obstacles around
the machine.
6.
7.
8.
Caution
Make sure that the covers are correctly in
place and are not damaged.
Important
Starter operation must take 15 seconds or
less. If the engine does not start, stop using
the battery for 30 to 60 seconds to avoid
exhausting the battery.
Open the fuel cock.
This is near the fuel tank.
Sit on the seat.
Make sure that the parking brake is applied.
Make sure that the traveling pedal is in
neutral position.
Move the throttle lever to the middle position
between "High" and "Low".
Pull the choke knob.
Pull the choke knob half way for restarting,
as necessary.
Switch the ignition key to the "START"
position.
Important
Quickly returning the ignition key from the
"START" position to the "ON" position may
result in damage to the machine.
When the starter starts rotating and the
engine starts, slowly return the ignition key to
the "ON" position.
Check that the engine has started, and then
return the choke knob to its original position.
Shift the throttle lever to "Low", and then
warm up the engine.
Approximate warming-up time
3 to 5 minutes when the outside
temperature is less than 20 degrees
Celsius
2 to 3 minutes when the outside
temperature is 20 degrees Celsius and
over
Gradually move the throttle lever to "High".
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
・
・
11.
Handling Instructions
FS900
Handling Instructions
Page 5-17
Start/Stop of Engine
Содержание FS900
