Controller Parameters
Home Display
°C:
measured temperature in Celsius. Temperature units
can not be changed without entering the configuration.
Contact Customer Service if a different temperature unit is
required.
OP:
% output power demand; displayed in lower display
(cannot be changed).
C.id:
Controller identification number.
PrG:
Program number (displayed when a program is run-
ning.
IdHi:
Deviation High Alarm
tunE:
One-shot autotune enable.
run LiSt (Program Run List)
PrG:
Currently running program (only used on multi-pro-
gram models)
StAt:
Displays the program status [OFF, run (running
active program), hoLd (program on hold), HbAc (waiting for
process to catch up), End (program completed)] in the
lower display. The controller will default to “OFF.”
PSP:
Programmer setpoint temperature (displayed when a
program is running).
CYC:
Number of cycles remaining in program (displayed
when a program is running).
SEG:
Active segment number (displayed when a program
is running).
StYP:
Active segment type (displayed when a program is
running).
SEG.t:
Remaining segment time in segment units (dis-
played when a program is running).
tGt
: Target setpoint.
rAtE:
Ramp rate (only if rate segment).
PrG.t:
Program time remaining in hours (displayed when a
program is running).
17
O
PERATION
