12
4.
Remove opposite end of heater coil by
sliding terminal off of the tab.
5.
Install new heater coil.
6.
Replace bottom cover and secure.
7.
Turn hot plate upright and reconnect to
power supply.
Replacing cycle light
1.
Disconnect hot plate from power supply.
2.
Turn hot plate upside down and remove
bottom cover.
3.
Remove clip from cycle light. Disconnect
the two wires from cycle light.
4.
Remove the cycle light.
5.
Insert new cycle light and secure with clip.
6.
Reconnect wires to the cycle light.
7.
Replace bottom cover and secure.
8.
Turn hot plate upright and reconnect to
power supply.
Replacing the control
1.
Disconnect hot plate from power supply.
2.
Turn hot plate upside down and remove
bottom cover.
3.
Remove knob and washer/spacer from
adjusting shaft.
4.
Disconnect the two wires from the control.
M
AINTENANCE
AND
S
ERVICING
Note
To prevent short circuit and for
best results, position heater
coil parallel to bimetal contact
arm with
13/64" clearance.
Содержание HP18300
Страница 16: ...16 Exploded View...
