Barnes 3SF-L Series Скачать руководство пользователя страница 7

Страница: 7 / 20

General Comments:

1) Never work in the sump with the power on.

2) Level controls are factory set for a pumping differential

of 9 inches. If that is the cycle desired, simply circle

the discharge pipe with the pipe mounting strap, feed

the end through the worm drive, and tighten with a

screwdriver. Be certain that the level control cannot

hang up or foul in its swing. Also, make certain the

pump impeller is still submerged when the level control

is in the “OFF” mode.

3) If a higher pump differential is needed, grip the cord

near the neck of the

oat, then using the other hand,

exert a steady force on the lower edge of the cable

clamp. The cable clamp should slide up to the new

pivot point. Attach the level control to the discharge

hose in the manner described above.

4) Plug the level control plug into the GFI receptacle,

then plug the pump into the piggyback plug. One cycle

of operation should be observed, so that any potential

problems can be corrected.

5) It is recommended that the

oat should be set to

insure that the sump well liquid level never drops

below the top of the motor housing or a minimum level

of 3 inches on BP Series and 6 inches on SE Series

above the pump bottom.

6.) Figure 3 shows a typical connection for pumps with the

wide

angle

oat and piggy-back plug, for manual and

automatic

operations.

Automatic -

Plug

oat cord into outlet, then plug pump

cord into

oat cord.

Manual -

Plug pump cord directly int outlet.

C-4) Electrical Connections:

An acceptable motor control switch shall be provided at the
time of installation.

C-4.1) Power Cords:

The cord assembly mounted to the pump must not be modi

in any way except for shortening to a speci

c application.

Any splice between the pump and the control panel must
be made in accordance with all applicord electric codes. It is
recommended that a junction box, if used, be mounted outside
the sump or be of at least Nema 4 (EEMAC-4) construction if
located within the wet well.

DO NOT USE THE POWER OR

CONTROL CORD TO LIFT PUMP.

NOTE:

THE WHITE WIRE

IS NOT A NEUTRAL OR GROUND LEAD, BUT A POWER
CARRYING CONDUCTOR.

C-4.2) Overload Protection:
Single Phase -

The type of in-winding overload protector used

is referred to as an inherent overheating protector and operates
on the combined effect of temperature and current. This means
that the overload protector will trip out and shut the pump off
if the windings become too hot, or the load current passing
through them becomes too high. It will then automatically
reset and start the pump up after the motor cools to a safe
temperature. In the event of an overload, the source of this
condition should be determined and recti

ed immediately.

NOT LET THE PUMP CYCLE OR RUN IF AN OVERLOAD
CONDITION OCCURS !

If current through the temperature sensor exceeds the values
listed, an intermediate control circuit relay must be used
to reduce the current or the sensor will not work properly.

TEMPERATURE SENSOR ELECTRICAL RATINGS

Volts

Continuous

Amperes

Inrush

Amperes

110-120

3.00

30.0

220-240

1.50

15.0