Barnes 2SEV, Инструкция по установке и эксплуатации

Страница: 14 / 32

F-4.3) Wiring Connections:
Check power cables (16) and control cable (56, if used), for
cracks or damage and replace if required (see Figure 12). Make
internal wiring connections which are independent of the
terminal block as shown, using connectors (48) and wire
assemblies (49) as required. Do not use wire nuts. Slip motor
leads and ground wire into fiberglass sleeve. Lower motor
housing (6) down onto seal plate (5) while aligning holes and
stringing motor leads through the cable entry bore(s). (Slipping
cords inside a 1 ft. length of .5” conduit makes this easier).
Place socket head cap screws (47) through seal plate (5) into
motor housing (6) and torque to 60 in-lbs. Reconnect motor and
optional control leads to the underside of the terminal block(s)
(21), (54 optional) as shown in Figure 13. Note that the pins are
numbered underneath the terminal block. Place o-ring (20) into
groove in terminal block and lubricate with dielectric oil. Press
the terminal block (21) into the housing so it seats completely
below the snap ring groove. Place snap ring (19) into groove in
cable entry bore of housing. Repeat terminal block installation
for control cable, if equipped.
F-4.4) Cable Assemblies:
Power/Control Cable- Refill the cooling oil as outlined in
paragraph F-1.3. Make wire connections as outlined in
paragraph F-4.3. Insert female end of cable plug into housing
bore aligning timing mark with hole in terminal block (21), see
Figure 14. Compress cable plug with compression flange (16a)
by tightening hex bolts (11) into the housing (6). Torque to 132
in-lbs.
Fig. 14
Fig. 12
Fig. 13
SINGLE PHASE - 240 VOLT AC (PSC)
14