Barmesa Pumps 2KTM201, Инструкция по установке, эксплуатации и обслуживанию

Страница: 18 / 42

3. Handle the pump carefully. When suspending the pump to raise or to lower it, attach a wire rope or a chain to the
pump's handle.
17
NOTE
For details on the water level necessary for pump operation, refer to the section on 'Water Level During
Operation" on page 25 of this manual.
6. When using a hose to provide piping to the pump, observe the following: Use the shortest possible length of
discharge hose and minimize the number of bends. Verify that the end of the hose (discharge side) is lifted above the
water surface. If the end of the hose is submerged in water, it may cause the water to flow back when the pump has
been stopped. If the end of the hose is located at a level that is lower than that of the source water surface, water may
continue to flow out even after the pump has been stopped.
4. Install the pump only in an area that can maintain a proper water level.
5. The discharge hose can be run vertically or horizontally, but must be without sharp bends.
barmesapumps.com