Preliminary Development
–
BARIX IP AUDIO MODULE 400
–
V 02.20
–
9.April.2018
Hardware
6
Hardware
Mechanical drawing
The Barix IP AUDIO MODULE 400 provides five, standard 2,54mm
spacing, single row pin headers, intended to match target connector or
motherboard, also suitable to soldering.
For mechanical fixation, the board provides two 2.7mm mounting holes
for 2.5mm screws.
The total size is 56.1mm +/-0.2 by 33.0mm +/-0.2.
Maximum component height is 5.6mm. Using standard distance bolts of
6mm a total height of 9mm above the carrier board can be achieved
when mounted on a carrier board by means of soldering the pin headers
into holes of the carrier board directly.
Using single row female headers (counterpart to pin headers) the height
will increase and must be measured by the integrator (our experience in
production shows a minimal height of 11.5mm above the carrier board
without using distance bolts and 12mm using 9mm distance bolts).
Although the total height is increased, the advantage of being able to
replace a module should be considered.
The above drawing shows the component side which faces down onto
the carrier PCB.
Dimensions are metric (mm)
Drawing is not to scale
Tolerance of PCB dimension is +-0.2mm, others 0.1mm
