5
• Rotate the chiller door through 180°, lift the
door with the hinge pin into the top hinge
bracket.
• Slide the lower hinge pin into the door and
carefully lift the base of the door onto the
lower mounting bracket lining up the fixing
holes as you go.
•
Screw the two lower hinge fixing screws in
place.
• The door will now hinge from the opposite
side.
• OPERATION
• Starting Operation
, Before you turn on your
chiller ensure the cabinet has been cleaned.
• Allow the installed chiller to stand for at least
30 minutes prior to use.
• Check around the unit for damage.
• Ensure the unit is level, all feet adjusted
correctly and taking the weight evenly.
• When powered up the chiller should chill within
1 hour, if not check the power supply.
• Control Panel
• Lock/Unlock
• The unit will be in lock mode when turned on.
• Press and hold the On/Off and Light buttons
simultaneously for 3 seconds to unlock.
• Repeat this if you want to engage the child
lock mode.
• On/Off
• Press and hold for 3 seconds to release from
stand by mode
• Press and hold for 3 seconds to go into stand
by mode.
• Light
• Press the light switch to turn the lights in the
chiller on or off (this function does not work in
stand by mode).
• Up
• Press the Up key once and the display will
show the current SET temperature
• Keep pressing to increase the current SET
temperature. (1 press = 1°C increase).
•
The new SET temperature will flash for
5 seconds and then return the current
temperature in the chiller.
• Down
• Press the Up key once and the display will
show the current SET temperature
• Keep pressing to decrease the current SET
temperature. (1 press = 1°C decrease).
•
The new SET temperature will flash for
5 seconds and then return the current
temperature in the chiller.
• Temperature display
• Switch from Celsius to Fahrenheit by pressing
and holding down the Up and Down arrows
simultaneously for 3 seconds.
• Suggested settings
• Red Wine ...............15-18°C
• White wine .............. 9-14°C
• Rose wine ............. 10-11°C
• Champagne .............. 5-8°C
• Attention
• The default factory setting for the chiller is
12° C.
• The chiller temperature can be set between
5-20°C.
• If a malfunction occurs an audible alarm will
sound, press any key on the keypad to turn the
alarm off.
• If the temperature sensor fails the error code
E1
will show on the display for an open circuit
and
E2
will show for a short circuit.
• Try to use the shelf in front of the fan last to
help with airflow.
• MAINTENANCE
• Remove the power plug from the supply when
performing cleaning or maintenance.
• DO NOT
use abrasive or chemical cleaning
materials on any surface of the unit.
