4
• INSTALLATION
• The unit is designed to be free-standing.
Ventilation Space - a minimum space of 50mm
is required for the rear of the fridge and 30mm
for the top and both sides. This will maximise
the efficiency, performance and the life of the
fridge and also ensure that there is sufficient
space for the hinge to operate effectively.
• Locate the unit away from direct sunlight or
sources of heat i.e. radiator, stove etc. Extreme
or cold ambient temperatures may also
prevent the unit working effectively.
• DO NOT
locate the unit in a damp location.
•
Ensure that the floor surface is strong and
stable enough to support the unit when it is
fully loaded.
• Level the unit when in location by using the
adjustable levelling feet in each corner.
• Once in position allow the unit to rest for an
hour before turning it on.
• REVERSING THE DOOR HINGE
• Your chiller is supplied hinged on the right as
you view it, if you want to reverse the door
follow the sequence below.
1)
• Open the door to 90° and hold it steady.
Unscrew the lower hinge screws (1+2) from
the pivot bracket (3).
2)
• Pull the base of the door away (arrow) until it
clears the bottom hinge (3) and drop the door
slightly to release from the top hinge plate (4).
Lift the door away from fridge unit.
3)
• Unscrew the top and bottom hinge mounting
plates from the face of the chiller (retain these
should you need to change the hinge back at a
later date).
4)
• Take the new (Left hand) hinge mounting
brackets and screw them to the left side upper
and lower mounting locations as shown (7+8)
as supplied with the unit.
