Manual 2100-578L
Page
8 of 42
Center of Gravity
"Z"
"X"
"Y"
MIS-3268
CENTER OF GRAVITY
Tip unit from left side only.
Failure to do so may result in injury due to unit
top-heaviness or compressor damage!
MIS-3268
A forklift or a lift rated for the load (Figure 2A) is
required to lift the unit off from the skid. This unit is
top heavy and should never be tipped while moving it.
The I-TEC is designed to be lifted off the skid from the
front or rear of the unit without having to remove any
doors or side panels. See Figure 1 for fork openings.
The shipping brackets on front and rear of the unit must
be removed and discarded. The unit can now be lifted
straight up and the skid can be slid out from underneath.
SHIPPING DAMAGE
Upon receipt of equipment, the unit should be checked
for external signs of shipping damage. The skid must
remain attached until the unit is ready for installation.
If damage is found, the receiving party must contact
the last carrier immediately, preferably in writing,
requesting inspection by the carrier’s agent.
UNIT REMOVAL FROM SKID
WARNING
This unit is heavy and requires more than one person
to handle during installation and removal from the
skid. Extreme caution must be taken to prevent injury
to personnel and damage to the unit. Use appropriate
safety equipment, including gloves when handling.
Failure to do so may result in serious injury.
Unit Tested
FRONT OF UNIT
DOOR TO CENTER
LEFT SIDE
TO CENTER
FLOOR TO CENTER
CRV & ERV
FLOOR TO CENTER
NO VENT
"X" Dimension
"Y" Dimension
"Z" Dimension
"Z" Dimension
I36Z1-A, B
13½"
31"
43½"
47"
I36Z1-C
13½"
31½"
43½"
47"
I48Z1-A, B
13½"
31"
43½"
47"
I48Z1-C
13½"
31½"
43½"
47"
I60Z1-A, B
13½"
31"
43½"
47"
I60Z1-C
13½"
31½"
43½"
47"
