Manual 2100-439
Page
GENERAL INFORMATION
This manual is intended to be a general guide for care and operation of typical systems and covers the
most important features you should be aware of and are responsible for as the user of the equipment.
The HAC outdoor unit may be connected to an indoor blower coil unit, or to an evaporator coil used in
conjunction with a gas or oil furnace. A separate owner’s manual should be supplied with the indoor
section. Therefore, you should request a detailed operation sequence and explanation of any special
features from your installer and/or Service Company, and also have them instruct you as to any routine
maintenance procedures you are responsible for.
AIR FILTERS
While air filters are not a part of the HAC-Series outdoor section, they are an integral part of the indoor
section to which the HAC unit is attached.
Keeping clean air filter(s) is the single most important responsibility of the user of the equipment. Each
type of system must be equipped with an air filter(s) in the indoor circulating air system to clean the air,
to keep the system itself clean for peak efficiency and capacity, and to prolong the useful life of the
equipment. DO NOT operate the system without the proper air filters.
Filters should be inspected at least monthly, and replaced or cleaned (depending on type) as needed.
The useful life of an air filter can vary widely depending upon application and use of the equipment, and
it is critical to monitor filter condition and establish an acceptable maintenance schedule. Failure to do
so will increase operating and repair costs, decrease capacity and efficiency, and shorten the service life
of the equipment. A common symptom of a dirty filter in the cooling mode is a freeze-up of the indoor
coil.
The air filters used may be a disposable (throw-away) type or may be a cleanable type that can be
thoroughly cleaned, rinsed and reused many times. It is important to make sure that the correct filter
size and type for your system is always used. If there is any question as to acceptable filter size or type,
review the Installation Instructions for the specific equipment involved, if available. Otherwise, consult
with your installing dealer or Service Company.
Most equipment can have the filters inspected and serviced by the user with no problems. In some
instances, because of equipment design or specific installation conditions, it may be necessary to have
this procedure done by a qualified service company. Have your installer or service company show you
where the filter(s) are and demonstrate the service procedure or make arrangements for them to provide
this service on an as needed basis.
OUTDOOR COIL
The outdoor coil must be kept clean and free of any airborne debris, which can accumulate over time.
Large volumes of air are circulated over the coil, and airborne debris such as lint, dust, materials shed
from trees, paper or other types of airborne material that can become airborne can collect on the enter-
ing coil surface.
The outdoor coil must dissipate heat during the cooling mode, and for a heat pump must also absorb
heat during the heating mode. If the coil is dirty and matted with debris, the airflow across the coil will be
reduced causing poor performance, increased operating runtime and associated utility bills, and in
extreme conditions can shorten the useful life of the equipment.
1
