Bard ERVF-A3, Руководство по установке, Страница: 14 / 15

Manual 2100-512B
Page
14 of 15
Belt Replacement
Instructions
MIS-1890
Route this part of replacement
belt in bottom groove of pulley.
Route this part of replacement
belt in top groove of pulley.
If belt "squeaks" or "chirps"
lubricate lightly with LPS-1
or equivalent "dry film"
lubricant.
Annual Maintenance
1. Inspect and conduct the same procedures as
outlined under
Quarterly Maintenance
.
2. To maintain peak latent (moisture) removal
capacity, it is recommended that the energy
recovery wheels be sprayed with a diluted nonacid
based evaporator coil cleaner or alkaline detergent
solution such as 409.
NOTE: Do not use acid-based cleaners, aromatic
solvents, temperatures in excess of 170°F or
steam. Damage to the wheel may result.
Do not disassemble and immerse the entire
heat wheel in a soaking solution, as bearing
and other damage may result.
3. Rinse wheel thoroughly after application of the
cleaning solution and allow to drain before re-
installing.
4. No re-lubrication is required to heat wheel bearings
of the drive motor, or to the intake and exhaust
blower motors.
5. If any belt chirping or squealing noise is present,
apply a small amount of LPS-1 or equivalent dry
film lubricant to the belt.
FIGURE 7
Belt Replacement Instructions
(Two Wheel Cassette Only)