Manual 7960-849
Page
2 of 4
Installation
1. Disconnect all power to wall mount before
installing sensors.
2. Remove inner and outer control panel covers.
Remove electric heater access panel, service panel
and blower access panel.
3. Install the airflow switch assembly using two (2)
hex head screws. Use the holes in the blower
partition shown in Figure 1.
4. Route the wires into the control panel.
5. Install the filter switch assembly. Refer to 7960-
853 instructions provided with the CMC-31 kit.
AIRFLOW SWITCH
MOUNTING HOLES
MIS-4077 A
WIRES FROM BOTH AIR FLOW
AND DIRTY FILTER SWITCH ARE TO
BE ROUTED DOWN AND THROUGH
THIS HOLE IN CONTROL PANEL
AIRFLOW
SWITCH ASS'Y
AIRFLOW SWITCH ASS'Y
IS TO BE MOUNTED WITH
TWO SCREWS IN BLOWER
PARTITION
FIGURE 1