Barco UDM Series, Руководство по установке

Страница: 49 / 104

49 R5911438 /08 UDM
4.5 Setting the projector addresses
Projector address
Address installed in the projector to be individually controlled via the RCU or via the serial
communication.
Broadcast address
Projector will always execute the command coming from a RCU programmed with that broadcast
address.
About individual projector address
As more than one projector can be installed in a room, each projector should be separately addressable with
an RCU or with a computer using serial communication. Therefore each projector has its own address. The
factory default individual projector address is ‘0’.
When the address is set, the projector can be controlled with the RCU. Only addresses between 0 and 31 are
supported for the RCU.
Next to an individual projector address, each projector has also a broadcast address for group control.
About broadcast address
Broadcast address is a common address that can be set on the projector. That can be “0” or “1”. The default
broadcast address is '0'.
Any command coming from an RCU programmed with that common address will be executed.
How to set
1. In the main menu, select System Settings > Communication > IR Control .
For detailed instructions see user guide of the projector.
Installation procedures