49
RLM
W12
ScenergiX
The function of ScenergiX is applied in multiple projectors that are projecting at the same
screen simultaneously to adjust the uniformity of the images on the screen.
•
Status
Press ENTER to select ON or OFF. The function must be set to ON in order to enable the
function of ScenergiX. If the function is set to OFF, the function of ScenergiX is disabled.
•
White Level
→ white level is to set the line from one projector where the other projector last
pixel ends. Press▲▼◄► to adjust the white level of the Top. Bottom, Left, Right direction on
the projected image.
As shown in the below drawing, the area D is the overlap area of the projected image 1 and the projected
image 2. The white level lines that is set where the other projector last pixels ends. Color adjustment for
matching the images is done with projector toolset with customs color space x and y or with input balance
on the OSD.
•
Black Level
→ the purpose of black level is in order to compensate the non overlap zones
vs the over lap zone. It increase the black level to the brightness level of the overlap black.
It is to adjust the black level of the Top, Bottom, Left, Right direction on the projected
images.
It can be set to adjust the primary color of the projector. For instance, select ALL is to
adjust the primary color of Red, Greed, and Blue. Or it can be set to adjust the Red, Green
and Blue independently.
Note: The function combination of Black Level adjustment and 4 Corners is not available
Note: The function combination of Black Level adjustment and blend along corners is not available.
Image 1
Image 2
A
B
C
D
White Level Lines
Image 1
Image 2
A
B
C
D
White Level Lines
for black level adjustment a black image
needs to be connected on the 2 projectors.
Zone B will have the sum of the blacks
of the 2 projectors. Set the adjustment
line of the black level to the position
where the non active DMD's of the
right projector ends. Set the adjustment
line of the black level to the position
where the non active DMD's of the
left projector ends. Adjust black level
of projector A to match the black level
with zone B. Adjust the projector C to
match the black level with zone B.
Blend along
corners
•
Reset
The function can reset the ScenergiX settings on the projector. It will restore to the
images to the default that is without any ScenergiX functions enabled.
•
Adjust Lines
When the function is ON, there will be adjust lines on the image in order to easily adjust
multiple images. Press ▼▲◄► on the remote control to adjust the position of the lines on
the image.
The image below is an example if 2 projectors are projecting at the same image.
1. Horizontally place two projectors and have the two projected images with an
overlap area and use the focus/zoom and lens shift functions with test grid
pattern to set a
proper overlap area for blending with a matched grid size.
OSD Menu description