Barco PH series, Руководство пользователя и инструкция по установке

Страница: 56 / 143

5. Advanced menu
Item
Setting
Function
NETWORK
CERTIFICATION
ON / OFF
Select whether to enable the network certi fi cation or not. Select OFF
for normal use.
IP CONFIG
ENTER
Select this setting for IP Con fi guration.
DHCP ON Select this setting when you obtain IP CONFIG automatically by
DHCP server.
OFF Select this setting when you set IP CONFIG manually.
IP ADDRESS
***.***.***.***
Press the ENTER key to set IP ADDRESS. When DHCP is set to ON,
you cannot change this setting.
SUBNET MASK
***.***.***.***
Press the ENTER key to set SUBNET MASK. When DHCP is set to
ON, you cannot change this setting.
DEFAULT GATEWAY
***.***.***.***
Press the ENTER key to set DEFAULT GATEWAY. When DHCP is set
to ON, you cannot change this setting.
MAC ADDRESS
xx-xx-xx-xx-xx-xx
Displays MAC ADDRESS.
SAVE SETTINGS
OK
Saves the IP CONFIG settings. When the IP CONFIG is not changed,
you cannot select SAVE SETTINGS.
CONTROL SYSTEM
STANDARD
Select this setting when using Projector Toolset.
AMX
Select when using a controller made by AMX.
CRESTRON
Select this setting when using the controller or software of Crestron
Electronics, Inc.
NETWORK RESET
OK
Resets the Network Setting.
NETWORK RESTART
OK
Press the ENTER key to restart the network function.
• AMX does not support network certi fi cation. When setting CONTROL SYSTEM to AMX, set NETWORK CERTIFICATION to
OFF.
5.10 INFORMATION menu
Overview
IMAGE INSTALL1 INSTALL2
MULTI-
SCREEN FEATURE SIGNAL NETWORK
INFO
60.00 Hz
RESOLUTION 1024 x 768
VERTICAL
FREQUENCY
48.36 kHz
5 WIRE
HORIZONTAL
FREQUENCY
SYNC. TYPE
SERIAL NUMBER
FILTER TIME
*****
H
********
...
NEXT LAMP RELAY
COMPUTER1 INPUT
*
D
**
H
LAMP 1 TIME (LOW)
LAMP 2 TIME (LOW)
****
H
****
H
Image 5-20
Item Description
LAMP 1 TIME (LOW) This item shows the lamp operation time calculated based on that the LAMP MODE of LAMP
1 is LOW.
→ When the LAMP MODE is STANDARD, this item shows a longer lamp operating time than
the actual time.
→ When the lamp operating time is 0 to 10 hours, “0H” is displayed. The lamp operating time
exceeding 10 hours is indicated by the actual hours.
→ When the lamp operating time reaches 3000 hours, the bar turns to yellow. When it reaches
3800 hours, the bar turns to red.
→ The icon displayed to the right of the bar shows the lamp status. Yellow: On, Red: End of lamp
life or error such as illumination failure, Black: Off
52 R5905597 PHXX SERIES 20/05/2014
Downloaded From projector-manual.com Barco Manuals