Barco PH series, Руководство пользователя и инструкция по установке

Страница: 38 / 143

4. Getting started
- The STATUS Led will go out.
- If the power cord should be unplugged accidentally while either the air inlet fan or the air outlet fans are operating or the lamp
is on, allow the projector to cool down for 10 minutes with the power off. To light the lamp again, press the ON/OFF key. If the
lamp doesn’t light up immediately, press the
ON/OFF key a few minutes later. If it should still fail to light up, replace the lamp.
- Cover the lens with the lens cap to protect it from dust.
Direct Power OFF
You can turn off this projector just by unplugging the power cord without pressing the ON/OFF key.
• Don’t shut down the projector while the STATUS Led is blinking after the lamp lights up because the lamp’s life may be short-
ened.
• Don’t turn the projector back on right after shutting it down because the lamp’s life may be shortened. (Wait about 10 minutes
before turning the projector back on.)
• Before shutting down the projector, be sure to close the menu screen. If you shut down the projector without closing the menu,
the setting data of the menu may not be saved.
• Don’t shut down the projector while the fi lter is rolling.
4.5 Adjusting the position of the projected image
What can be done?
If the projected image is out of the screen after the adjustment, adjust the projector position or the lens position using the lens shift
function.
How to adjust
1. Press the OK key to display the LENS FOCUS/ LENS ZOOM menu.
Image 4-5
2. Adjust with the ◄ or ► key to get a fi ne picture.
3. Adjust with the ▲ or ▼ key to get an approximate size.
4. Press the OK key.
The LENS SHIFT menu appears.
Image 4-6
5. Press the ▲ , ◄ , ▼ or ► key to move the image position.
34 R5905597 PHXX SERIES 20/05/2014
Downloaded From projector-manual.com Barco Manuals