Barco Nio Fusion12MP, Руководство пользователя

Страница: 28 / 66

R5913350 /02 Nio Fusion 12MP 28
The SoftGlow lights can also be enabled and configured in the Intuitive Workflow Tools. See the
Barco
“ Display Controller and Intuitive Workflow Tools ” user guide on the included documentation
CD, or at www.barco.com/support.
To adjust the SoftGlow Wall light brightness
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Lights menu.
3. Enter the SoftGlow Wall Light brightness submenu.
4. Set a SoftGlow Wall Light brightness value as desired and confirm.
The SoftGlow lights can also be enabled and configured in the Intuitive Workflow Tools. See the
Barco
“ Display Controller and Intuitive Workflow Tools ” user guide on the included documentation
CD, or at www.barco.com/support.
4.7 DPMS mode
About DPMS mode
Enabling the Display Power Management System (DPMS) mode on your display will optimize its diagnostic
lifetime by automatically switching off the backlight when the display is not used for a specified period of time.
By default, DPMS mode is enabled on your display, but it also needs to be activated on your workstation. To
do this, go to the
“ Power options ” of your workstation.
Barco recommends setting DPMS activation after 20 minutes of non-usage.
When DPMS mode is enabled, an additional power saving function becomes available: hibernate.
See
“ Hibernate ” , page 28 for more information.
To enable/disable DPMS mode on your display:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Power Management menu.
3. Enter the DPMS Mode submenu.
4. Select Enabled/Disabled as desired and confirm.
4.8 Hibernate
About hibernate
When hibernate is enabled, not only the backlight, but also other functions will be disabled to reduce power
consumption to a minimum. This happens after an adjustable time-out.
DPMS mode must be enabled before hibernate can be enabled. See “ DPMS mode ” , page 28.
In a single workstation setup (see “ Single workstation setup ” , page 12), connect your keyboard,
mouse, touchpad, etc. directly with your workstation (and not with the display) to be able to use
them to awake your system from hibernate.
When your workstation and display don't awake from hibernate within 10 seconds after a keyboard
or mouse trigger, press the jog dial to awake your system.
Advanced operation