![background image](http://html.mh-extra.com/html/barco/mivd-1218/mivd-1218_user-manual_473726025.webp)
User manual MIVD 1218
25
Equal pix...................Selects the number of successive pixels with
the same digital value used in amplitude and
black level calibration.
Decrease this number for video signals with a
lot of noise.
Phase offset .............Adds a phase difference to the value derived
after phase calibration.
This can be used to compensate for distortions
on the video signal.
Apix Range...............Contains the functions Clk Start and Clk Stop.
These are the numbers of pixels for the Autocal
routine to start and stop with.
By default, the number of lines in the image is
taken as the number of pixels for Autocal to
start its calculations. The double of this start
number is taken as the number of pixels for
Autocal to stop. By increasing the start number
and decreasing the stop number, you narrow
the range for the Autocal routine. As a result,
Autocal goes faster.
OSD
Here you can change some of the on-screen display’s (OSD)
parameters.
These are the OSD settings:
Hor. Pos ...................The horizontal position
Vert. Pos...................The vertical position
Timeout On...............To switch the OSD timeout on or off. A check
mark (
3
) means it is switched on, a cross (
2
)
means it is off.
When switched on, the OSD disappears
automatically after 300 seconds of inactivity.
ALC
ALC (ambient light compensation) is a system that adapts the panel
light output automatically, based on the ambient light measured by
the ALC sensor at the front of the display.
Here you can adjust the ALC parameters.
These are the ALC settings:
min Light...................This is the panel light output that corresponds
to the minimum ambient light, measured by the
ALC sensor.
Содержание MIVD 1218
Страница 2: ......