![background image](http://html.mh-extra.com/html/barco/mivd-1218/mivd-1218_user-manual_473726011.webp)
User manual MIVD 1218
11
To connect analog video & sync signals:
Connect the video & sync output of the signal source to the video
and sync inputs (6), (7) and (8) of the display.
The inputs accept the following signals:
• Video with separate horizontal and vertical sync.
- The connection consists of 3 cables.
- Connect the video signal to the connector Video (6).
- Connect the horizontal sync signal to connector HS/CS (7).
- Connect the vertical sync signal to the connector VS (8).
- Make sure the signal connected to the HS/CS connector does
not contain Composite sync.
• Video with external composite sync.
- The connection consists of 2 cables.
- Connect the video signal to the connector Video (6).
- Connect the composite sync signal to connector HS/CS (7).
- Make sure no signal is connected to the VS connector.
• Video with internal composite sync (sync on video).
- The connection consists of 1 cable.
- Connect the video (with sync) signal to connector Video (6).
Notes:
• The video inputs cannot be connected in loop-through (daisy-
chain).
• The required video amplitude: 700 mV ± 3 dB.
• The required sync. amplitude: 500 mV.
To connect the power:
1 Plug one end of the power cord into the rear of the display
(connector (9)).
2 Plug the other end into a grounded AC power outlet.
3 The display automatically adapts to the voltage. The voltage
range is: 90-264 VAC.
After fixing the cables, put the connector compartment cover back in
place. Pay attention that the signal cables are positioned under the
bulge in the cover.
Содержание MIVD 1218
Страница 2: ......