Barco MDRC-1119 TS, Руководство пользователя

Страница: 22 / 66

22
Start Your Installation
Connecting the Display
Use only the power adapter which are the forming part of each
medical device, the power cord, and the video cable shipped with this
display.
CAUTION: For MDRC-1119 / MDRC-1119 TS: The universal external 12V
DC/ 5.0A power adapter (100-240V~, 1.5A, 50-60Hz for power adapter
rating) is the BridgePower (BPM060S12F09). For MDRC-2120: The
universal external 24V DC/ 2.7A power adapter (100-240V~, 1.5A,
50-60Hz for power adapter rating) is the BridgePower
(JMW190KB1200F09). For MDRC-1119 HB: The universal external 12 V
DC / 7.0A power adapter (100-240V~, 2.0A, 50-60Hz for power
adapter rating) is the BridgePower (JMW190KB1200F09).
To setup this display, please refer to the following figure and
procedures.
1. Be sure all equipment is turned off.
2.
Connect the DC power cord to the power connector; plug one
end of the AC power cord into the power adapter, and the
other end into an electrical outlet. (
1).
3.
For a PC with Analog output: Connect the VGA signal cable
from display VGA input connector to the 15-pin connector of
your host computer and tighten the screws. (
2).
4.
For a PC with DVI digital output: Connect the DVI signal cable
to the connector of the display card in your computer, connect
the other side to the DVI-D input port of your display. Tighten
the screws (
3).
5. Turn on your computer, display and video source.
Note: To ensure the LCD Display will work well with your computer,
please configure the display mode of your graphics card to make it less