Barco MDNG-5221, Руководство пользователя

Страница: 24 / 52

5. Advanced operation
5.9 Hibernate
About hibernate
Enabling hibernation will not only switch off the backlight but will also force the display to disable other
functionalities so that power consumption is further reduced to a minimum. This happens after a speci
fi c
period of time which can be manually adjusted.
Hibernate can only be enabled on your display when the DPMS mode is enabled fi rst.
Therefore, please refer to "DPMS mode", page 21 to do this.
To enable/disable hibernation on your display:
1. Bring up the OSD main menu.
2. Navigate to the Con fi guration > Power Management menu.
3. Enter the Hibernate submenu.
4. Select Enabled/Disabled as desired and con fi rm.
To specify the hibernate timeout:
1. Bring up the OSD main menu.
2. Navigate to the Con fi guration > Power Management menu.
3. Enter the Hibernate Timeout submenu.
4. Set the timeout value as desired and con fi rm.
5.10 Luminance target
About the luminance target
The luminance target of your Nio 5MP LED Display is adjustable over a prede fi ned range. When you
change the luminance target, the display will adjust its backlight to reach the target.
To set the luminance target:
1. Bring up the OSD main menu.
2. Navigate to the Con fi guration > Calibration menu.
3. Enter the Luminance Target submenu.
4. Set a luminance target value as desired and con fi rm.
The default, factory DICOM calibrated luminance value is available in the technical spec-
i
fi cations table. The guaranteed backlight lifetime is valid for this setting.
5.11 Viewing modes
About viewing modes
The Nio 5MP LED Display can be used in two viewing modes:
22 K5902091 NIO 5MP LED DISPLAY 09/01/2015