Barco iQ Reality 500, Руководство пользователя

Страница: 40 / 141

4. Getting started
The total lifetime of the lamp for a safe operation is “x” hours max, do not use it longer. Always replace with a same type of lamp.
Call a BARCO authorized service technician for lamp replacement.
BarcoIQ x ( Max lamp runtime, in hours)
210L 6000
350 3000
500 1500
Table 4-3
Maximum runtime for the different BarcoIQ projectors
When the lamp runtime reaches “x” hours the projector switches automatically to the other lamp, being lamp2.. following messages
are displayed during and after switching.
Image 4-6
Image 4-7
When lamp2 at its turn reaches x-30 hours, a warning message appears on the screen.
Image 4-8
warning message in case of a IQ300 series projector
At the end of the lifetime of lamp2 ( x hours) the projector generates an alert message.
Image 4-9
A countdown time of 4 minutes is triggered before the projector is shut down (standby).
If the lamp runtime has not been reset, the alert message will reappear at the next start up (with again 4 minutes countdown time).
This alert message can be escaped with MENU or BACK , but the countdown continues.
Contact a qualified Barco technician for lamp replacement.
In Dual mode the lamp end of lifetimes are reached at the same time, however if in dual lamp mode one lamp
has been used more than the other (for example if the projector has been working temporarily in single mode),
one lamp will reach its end of lifetime sooner than the other lamp, which brings us to the Single mode oper-
ation.
W
ARNING
:
Using a lamp for more than x hours is dangerous as the lamp could explode.
The lamp runtime reset as well as the lamp replacement can only be done by a Barco authorized technician.
4.5 Lamp error
What happens in case of a lamp error ?
When a lamp error occurs in dual mode, a dialogbox is displayed informing the user of the steps to be taken.
36 R5976693 BARCOIQ REALITY 500 01/02/2007