Barco ImagePRO-II Jr, Дополнение к руководству пользователя, Страница: 94 / 166

ImagePRO-II • User’s Guide 79
4. Menu Orientation
Creating and Saving Views
•
Units defines the units you are using. The options are Pixel and Percent .
•
Fill H/V adjusts the image to fill the display both horizontally and vertically.
•
Save View saves the current input’s view settings. For more information, refer to
Saving a View to an Input on page 79.
•
Recall View recalls a saved view to the current input. For details, refer to
Recalling an Input’s Saved View on page 79.
•
Reset sets all view settings for the current input to their default values. If you have
saved a view for this input, that view remains in memory after you reset, and can
be recalled again later.
For information about using this feature when you have the 3D/Dual Channel option
installed, refer to
Creating a View in Dual-Channel Mode on page 111 of this chapter.
p~îáåÖ=~=sáÉï=íç=~å=fåéìí
On the Zoom/Pan Submenu , the Save View option saves your view to the current input
only. You can save one view for an input. The save persists across power cycles for this
input.
If you save the view using this menu, you will not be able to recall it later for use on other
inputs. Nor does this option permit naming the view.

To save a view to the selected input, use the following procedure:
1. Create the view settings as described in Creating a View on page 78. Press SEL
after each setting you adjust.
2. When you finish adjusting settings, press SEL .
3. Scroll to Save View , and press SEL again.
A confirmation message appears, and your view is applied to the selected input.
When you have adjusted the pan and zoom settings for the current input, you have the
option of saving this view to the system. To name and save a view for future recall, refer to
Saving a View to the System on page 80.
oÉÅ~ääáåÖ=~å=fåéìíÛë=p~îÉÇ=sáÉï=

To recall a view you saved to a specific input, use the following procedure:
1. Select the input and press PAN/ZOOM .
2. On the Zoom/Pan Submenu , select Recall View .
The image adjusts to the saved view settings.
oÉëÉííáåÖ=~å=fåéìíÛë=aÉÑ~ìäí=sáÉï

To restore the default view on an input, select Reset on the Zoom/Pan Submenu .
Note Using Recall View on the Zoom/Pan Submenu , you can
only recall the single view you saved to the input. If you wish
to apply a view that you saved to the system, refer to
Recalling a System View on page 81.