Barco ICMP, Руководство по установке

Страница: 15 / 18

R5905769 /04 ICMP/ICMP-X HDD 15
Image 1-7
4. Pull the HDD out of its slot.
Image 1-8
To install an HDD, see the following procedure: “ Installing a HDD into the ICMP ” , page 15.
1.6 Installing a HDD into the ICMP
This procedure assumes that the HDD slot of the ICMP is empty. If not, see procedure “ Removing a
HDD from the ICMP ” , page 14.
CAUTION: Always use a new empty spare part HDD approved by Barco to replace a malfunction
HDD. Do not use a HDD from another ICMP HDD set.
CAUTION: Always make sure that all HDDs in the ICMP HDD set have the same storage capacity.
See label on top of the HDD to know the storage capacity.
Re-initialization or rebuild of RAID
Installing or exchange one or several HDDs into ICMP has an impact on data presents on the already inserted
drives. RAID integrity depends on the type of HDD swap. Refer to the chapter
“ What are the possible HDD
swaps ” , page 11.
How to install a HDD ?
1. Ensure that the projector is switched off.
2. Prepare the HDD for insertion by moving the latch towards the left and push the unlock button to open the
handle.
HDD(s) on ICMP