Barco HDF W series, Инструкция по использованию и установке

Страница: 60 / 319

5. Getting started
F1
F2 F3 F4
F5
ADJ EXIT
ENTER
PAUSE
PHASE
TEXT
SHARPN
TINT
COLOR
BRIGHTN
CONTR
TREBLE BALANCE
BASS VOL
9 0
7 8
5 6
3 4
1 2
F1
F2
F3
F4
F5
ADJ EXIT
ENTER
PAUSE
PHASE
TEXT
SHARPN
TINT
COLOR
BRIGHTN
CONTR
TREBLE BALANCE
BASS VOL
9 0
7 8
5 6
3 4
1 2
45°
45° 45°
45°
45°
45°
F1
F2
F3
F4
F5
ADJ EXIT
ENTER
PAUSE
PHASE
TEXT
SHARPN
TINT
COLOR
BRIGHTN
CONTR
TREBLE BALANCE
BASS VOL
9 0
7 8
5 6
3 4
1 2
Image 5-7
RCU to one of the IR sensors
5.8 Projector Address
5.8.1 Displaying and Programming addresses into the RCU
Displaying the Projector Address on the Screen.
Press Address key (recessed key on the RCU) with a pencil.
The projector’s address is displayed on the local LCD screen.
To continue using the RCU with that speci fi c address, it is necessary to enter the same address with the
digit buttons (address between 0 and 9) within 5 seconds after pushing the address key. For example : if the
Address key displays projector address 3, then press "3" digit button on the RCU to set the RCU’s address
to match the projector’s address. Do not press 03. This will address the remote control to ’0’ and control all
projectors in the room. If the address is not entered within 5 seconds, the RCU returns to its default address
(zero address) and controls all projectors in the room.
How to Program an Address into the RCU?
Press the Address key (recessed key on the RCU) with a pencil.
Enter the address with the digit buttons within 5 seconds after pushing the address key.
Note: That address can be any digit between 0 and 9.
The LED on the remote control must lit up while pressing a digit key. Otherwise the address is not entered in
the remote control.
5.8.2 Controlling the projector
Projector address
Address installed in the projector to be individually controlled.
56 R5905158 HDF SERIES 16/06/2015