Barco Galaxy NW-7, Руководство пользователя

Страница: 130 / 220

7. Advanced
4. Use ↑ or ↓ to select CLO
5. Press → to pull down the menu
6. Use ↑ or ↓ to select Target
7. Press → to pull down the menu
8. Use ↑ or ↓ to select Normal Mode ...
9. Press ENTER
A dialog box is displayed
Image 7-134
10.Use ← or → , the numeric keys on the remote, or the keypad to change the target value.
How to set the CLO target when using the In fi tec
TM
Mode ?
1. Press MENU to activate the Tool bar
2. Press → to select the Lamp item
3. Press ↓ to Pull down the Lamp menu
4. Use ↑ or ↓ to select CLO
5. Press → to pull down the menu
6. Use ↑ or ↓ to select Target
7. Press → to pull down the menu
8. Use ↑ or ↓ to select In fi tec Mode...
9. Press ENTER
A dialog box is displayed
Image 7-135
10.Use ← or → , the numeric keys on the remote, or the keypad to change the target value.
7.7.5.3 Linked CLO
Introduction
Projectors in a multichannel setup use the same kind of lamp. These lamps may slightly differ in their output and will in certain cases
have different runtimes, this will result in a difference in light output between the projectors.
By using the constant light output in a Master/Slave con fi guration, it is possible to track and maintain the brightness levels of the
projectors, the projectors will deliver an equal light output.
In a multichannel setup (max. 10 projectors ) it is possible to link the CLO values of all projectors. One projector will act as master,
all slave projectors will track and maintain the CLO setting of this master projector.
Following CLO Settings are available:
MASTER Master projector to control the CLO in a chain of projectors, the target value in the Master projector will be
the target value for all projectors set as slave and which are listed in “Linked Projectors”
SLAVE Follows the master projector to adjust the CLO
OFF no linking ( note : if CLO mode is ON, it will applied on the projector itself)
Table 7-7
CLO Settings
126 R59770288 GALAXY NW-12, GALAXY NW-7 20/06/2013