Barco DP2K-12C, Руководство по установке

Страница: 19 / 111

3. Physical installation
3. PHYSICAL INSTALLATION
About this chapter
This chapter describes how the mechanical set up of the projector has to be done and how to realize the electrical connections.
Overview
• Positioning the DP2K C-series projector at port window
• Installation of the exhaust system
• Connecting the projector with the power net
• Power loop through to the projector electronics
• Connecting a UPS with the projector electronics
The light pipe is made out of magnesium. If used in high humidity conditions, there might be some corrosion
visible. However, this does not affect the performance of the projector.
3.1 Positioning the DP2K C-series projector at port window
W
ARNING
:
The installation of the DP2K C-series projector requires at least 4 persons.
General guide lines
• Use a solid pedestal to put the DP2K C-series projector projector on. Ensure that the pedestal can handle the weight of the
projector and that all feet of the projector are captured.
• The pedestal should be placed in front of the port window wall in a manner that the projector front cover is at a minimum distance
of 20 centimeters from the port window.
20 cm
Image 3-1
Positioning at port window
Barco offers a pedestal for the DP2K C-series projector. This universal pedestal allows a solid and easy setup
of the projector. The universal pedestal has a separate compartment to install the UPS unit (if available) for
the DP2K C-series projector. Futhermore, the universal pedestal contains a standard 19” rack to build in the
projector peripherals like alternative content switchers (e.g. ACS-2048).
Necessary tools
• 14 mm wrench.
• 17 mm wrench.
R5905050 DP2K C-SERIES 10/07/2012 13