Barco Custom power box, Руководство пользователя

Страница: 14 / 19

4. Physical installation
Image 4-2
4.2 Installation
W
ARNING
:
The following procedure must be performed by authorized an qualified technical personnel only.
C
AUTION
:
Make sure that the local power supply voltage correspond with the required input voltage of the
Custom Power Box. Wrong input voltage can cause damage to the power box and the equipment connected
to it.
Necessary tools
• Wrench 13 mm.
• Crosshead screwdriver.
• Volt meter.
Necessary parts
Four bolts M8 x 20.
Installation procedure
1. Instal the Custom Power Box on a safe location, which is only accessible by authorized persons. There is no need to disassemble
the Custom Power Box for installation. Each corner on the backside of the Custom Power Box is provided with a fixed M8 nut.
Use for every nut a M8 x 25 mm bolt for fastening the Custom Power Box. (image 4-3)
2. Open the door of the Custom Power Box and place all the circuit breakers in the OFF position.
3. Remove the lower cover plate inside the Custom Power Box by releasing four crosshead screws.
4. Guide the incoming power cable through the cable seal at the bottom of the Custom Power Box and insert the wires into the cor-
responding pins of the main connector. Make sure the wires are fastened and the cable seal is tightened. (image 4-4, image 4-5)
Warning: Make sure the power cable is powerless while handling.
Caution: The characteristics of the incoming power cable must comply with the local regulations regarding such installations.
5. Place the lower cover plate back inside the Custom Power Box.
10 R5976620 CUSTOM POWER BOX 05/06/04