![background image](http://html1.mh-extra.com/html/barco/coronis-fusion/coronis-fusion_getting-started-manual_3890436029.webp)
Installing the system
29
11.
Reconnect any cables you have disconnected and plug in the
computer’s power cord.
12.
Turn on the display(s) and then your computer.
Turning on your system
If you have properly installed your graphics card, the Windows
start-up messages will appear once the boot procedure is
finished.
13.
Install the drivers, QAWeb software and documentation for your
B
ARCO
C
ORONIS
F
USION
Display System by following the instructions
in the section
“Software installation”
on page 34 of this
manual.
Connecting the signal cables
To connect the signal cables to the display:
1.
Unpack the display and put it on a solid flat surface.
2.
Make sure the computer is turned off.
3.
To get access to the connectors, remove the connector
compartment cover (1).
WARNING
- Turn on your display(s) before you turn on
your computer. Failure to do so could damage your dis-
play(s).
Your Barco display(s) will be running in a basic video
mode at a default refresh rate. Higher resolutions and
refresh rates, such as 1536x2048@60Hz, are not avail-
able at this stage of the installation. Once you have
installed the B
ARCO
C
ORONIS
F
USION
Display System drivers
and software, the Barco monitor Plug and Play software
should automatically set the resolution for the displays
of your B
ARCO
C
ORONIS
F
USION
Display.
Содержание Coronis Fusion
