8
CLM W6
1. Safety
To prevent projector damage
If the Air Filters are not regularly replaced, the air flow inside the projector could
be disrupted, causing overheating. Overheating may lead to the projector shut-
ting down during operation. (The Air Filters are optional for this projector.)
In order to ensure that correct airflow is maintained, and that the projector
complies with electromagnetic compatibility (EMC) requirements, and for safety
requirements, it should always be operated with all of it’s covers in place.
Slots and openings in the cabinet are provided for ventilation. To ensure reliable
operation of the product and to protect it from overheating, these openings must
not be blocked or covered. The openings should never be blocked by placing
the product on a bed, sofa, rug, or other similar surface. This product should
never be placed near or over a radiator or heat register. The projector should
not be placed in a built-in installation or enclosure unless proper ventilation is
provided.
Do not block the projector cooling fans or free air movement under and around
the projector. Loose papers or other objects may not be nearer to the projector
than 40 cm (16") on any side.
The projector must always be mounted in a manner which ensures free flow of
air into its air inlets and unimpeded evacuation of the hot air exhausted from its
cooling system. Heat sensitive materials should not be placed in the path of the
exhausted air. Leave at least a free safety area of 1 meter (40") at the rear of the
projector.
Ensure that nothing can be spilled on, or dropped inside the projector. If this
does happen, switch off and unplug the mains supply immediately. Do not oper-
ate the projector again until it has been checked by qualified service technicians.
Consult a professional structural engineer prior to suspending the ceiling mount
from a structure not intended for that use. Always ensure the working load limit
of the structure supporting the projector.
Do not use this equipment near water.
Special Care for Laser Beams:
Special care should be used when DLP projec-
tors are used in the same room as high power laser equipment. Direct or indirect
hitting of a laser beam on to the lens can severely damage the Digital Mirror
Devices™ in which case there is a loss of warranty.
Save the original shipping carton and packing material; they will come in handy
if you ever have to ship your equipment. For maximum protection, repack your
set as it was originally packed at the factory.
