BlendPRO-II • User’s Guide
23
3. Installation
Rack-Mount Installation
o~ÅâJjçìåí=fåëí~ää~íáçå
BlendPRO-II units are designed to be rack mounted and are supplied with front rack-mount
hardware. Please note the following important points:
•
Rear rack-mount brackets are available as a kit, and are recommended for use
when units are mounted in transit cases.
•
When rack mounting the unit, remember that the maximum ambient operating
temperature for the unit is 40 degrees C.
•
Leave sufficient front and rear space to make sure that the airflow through the fan
and vent holes is not restricted.
•
When installing equipment into a rack, distribute the units evenly to prevent
hazardous conditions that may be created by uneven weight distribution.
•
Connect the unit only to a properly rated supply circuit.
•
Reliable grounding (earthing) of rack-mounted equipment should be maintained.
•
Rack mount the unit from the front rack ears using four rack screws (not supplied).
Rack threads may be metric or otherwise — depending upon the rack type.
•
Install the
lower
of the two mounting holes first.
mçïÉê=fåëí~ää~íáçå
Use the following steps to install power to the BlendPRO-II:
1.
Connect an AC power cord to the AC Power Connector on the rear of the
BlendPRO-II, and then to an AC outlet.
2.
Connect AC Power cords (or AC adapters) to all peripheral equipment, such as
ScreenPRO-II systems, monitors and projectors. Please note:
~
Connect each unit only to a properly rated supply circuit.
~
Reliable grounding of rack-mounted equipment should be maintained.
