61780 0221
REMOVAL AND REPLACEMENT OF CHANNEL STUDS 560B05095S (SIFTING BELT).
TOOLS RECOMMENDED
: Channel Stud Replacement Tool 504CM02, 5/8” socket or ratcheting wrench,
hammer, punch, oil. The Bucket Safety Support is REQUIRED when working at the rear of the conveyor
with the bucket elevated!
When the top of a channel stud has broken off from use, the stud must be replaced. The base of the
stud must be removed from the channel using a punch and hammer from the topside of the conveyor
belt. The washer can be reused. The replacement stud should be pushed through from the inside of the
conveyor belt. The stud’s splines can be aligned/turned into the grooves in the channel that were made
from the broken stud. Place the washer onto the stud and then thread the lightly oiled Channel Stud
Replacement Tool onto the stud by hand, as far as it will go. Tighten the tool until the head of the stud is
flush with the channel. The tool is threaded on both ends and each end will tighten between 10 -15
studs.
DO NOT
use power tools to install studs.
Please visit the
SURF RAKE Maintenance Video Section
of our website, by clicking the following link:
http://www.hbarber.com/customer-service/Maintenance/surf-rake-maintenance.html
4-8