Barbeques Galore G4CNSM, Инструкция по сборке и эксплуатации

Страница: 16 / 21

TO CHECK FOR LEAKS:
Make 100 ml of leak detecting solution by mixing one part washing up liquid with 3 parts water.
Ensure all the barbeque control valves are
“OFF”.
Connect the regulator to the cylinder, ensure the
connections are secure then turn ON the gas.
Brush the soapy solution onto the hose and all joints. If bubbles appear you have a leak, which must be
rectified before use. Check all connections are properly tightened. Retest after fixing the fault. Turn
“OFF”
at the gas at the cylinder after testing.
If leakage is detected and cannot be rectified. Do not attempt to use the barbeque, consult your store of
purchase.
Lighting Instructions for barbeque
1. Open the hood of the barbeque before attempting to light the main burners.
2. Turn all the control knobs clockwise to
“OFF”
position.
3. Connect the regulator to the gas bottle. Turn the gas supply
“ON”
at the gas cylinder. Check with
the use of soapy water as outlined above for any gas leakage between the bottle and the
regulator.
4. Push down the main burner control knob and keep pressing whilst turning anti-clockwise to the
“HI”
position (a clicking sound is heard). This will light the main burner .
5. If the burner has not lit after retrying once, turn the control knob
“OFF”
(clockwise) wait 5 minutes
and repeat step 4.
6. If the burner does not light. Light the appliance with a match using the lighting hole in the side of
the appliance. Consult your store of purchase if necessary to service the ignition.
Warning:
If the burner completely fails to ignite, turn the control knob
“OFF”
(clockwise) and also
turn the cylinder valve
“OFF”.
Wait five minutes before attempting to relight with ignition sequence.
7. Adjust the heat by turning the knob between the
“
HI
”
and
“LOW”
positions.
8. To turn the barbeque “ OFF
” turn the cylinder valve or regulator switch to the “
OFF
” position and
then turn the control knob on the appliance clockwise to the
“
OFF
” position.
Lighting Instructions (Side burner)
1. Open the lid of the side burner.
2. Push down the side burner control knob and keep pressing whilst turning anti-clockwise to the
“HI”
position (a clicking sound is heard), this will light the side burner . Observe if the burner has
lit. If not repeat this process.
3. If the burner has not lit after retrying once, wait 5 minutes and repeat step 2.
4. If the burner does not light. Light the appliance with a match using a long match or taper. Consult
your gas dealer to rectify the ignition.
Warning: If the burner fails to ignite, turn the control knob
“OFF”
(clockwise) and also turn the
cylinder valve
“OFF”.
Wait five minutes before attempting to relight with ignition sequence.
5. Adjust the heat by turning the knob between the
“HI”
&
“LOW”
positions.
6. To turn the side burner
“OFF”,
turn the control knob clockwise to the
“OFF”
position.
BEFORE USE CHECK FOR LEAKS
Never check for leaks with a naked flame, always use a soapy water solution