Barbecook CAMPO CERAM 223.7320.000, Руководство пользователя

Страница: 11 / 49

www.barbecook.com 11
11 TROUBLESHOOTING
Problem Probable cause(s) Solution(s)
Not enough heat • Gas supply not open
• Venturis not placed over openings of gas valves
• Burner openings blocked
• Gas cylinder (almost) empty
• Pressure regulator not connected correctly to
cylinder and/or hose
• Open gas supply
• Place venturis over openings of gas valves
• Clean burner openings or replace burners
• Replace gas cylinder
• Reconnect pressure regulator to cylinder and/
or hose
Heat not distributed evenly over
griddle surface
Some heat differences are normal.
Probable cause(s) for big heat differences:
• Appliance not preheated
• Preheat appliance
Yellow flames • Burners or venturis blocked
• Salt on burners
• Appliance connected to butane
• Clean burners and venturis
• Clean burners
• Connect appliance to propane, using an
appropriate pressure regulator
Incomplete flame • Burner blocked, pierced or rusted • Clean or replace burner
Flash-backs (flames outside
venturis/at control knobs) • Burners or venturis blocked • Close gas supply and set burners to OFF.
• Let appliance cool down.
• Clean burners and venturis.
Flames higher than edge of
bowl
• Lots of wind
• Gas cylinder (almost) empty
• Fat in bowl or on burners
• Put appliance with rear side towards wind
• Replace gas cylinder
• Clean bowl or burners
Pressure regulator hums
• Hot weather
• New (full) gas cylinder
Not a hazard or defect. Should stop automatically
after a while.
Burner whistles when set to
LOW
• Gas injector, venturi and/or burner dirty • Clean gas injector, venturi and burner
Impossible to light burner
(using either igniter or match)
• Burner or venturi blocked
• No gas supply
• Clean burner and venturi
• Open gas supply and press safety knob on
pressure regulator (not present on all regulators)
Sparks present that do not
originate from burners • Faulty wiring • Replace wiring