Barbecook CAMILLIA, Руководство пользователя

Страница: 31 / 122

www.barbecook.com 31
Yellow flames • Venturi tubes are partly blocked
• Salt on burner
• The product is connected to Buthane. • Clean venturi tubes
• Clean burner
• Connect the product to Propane with the right connector.
Impossible to light burner with igniter • Ignition wire not fitted properly
• Defective ignition electrode
• Faulty ground
• Defective igniter
• Check all connections
• Check installation of electrodes, burner and igniter
• Replace igniter
Flames jumping out of the burner box • Windy weather
• Cylinder almost empty • Move barbecue with rear side pointing towards the wind
• New cylinder or fill up
Excessive heat and flare-ups • Too fatty food
• Blocked fat drain hole
• Cooking system not positioned correclty • Trim excess fat or reduce heat
• Clean bottom of burner box and burner
• Position cooking system correctly
Flames behind control panel • Blocked venturi tubes • Shut off gas immediately, allow barbecue to cool down and
clean venturi tubes
Regulator humming • Temporary situation caused by high outside temperature or
full cylinder
• This is not a defect or a hazard
Incomplete flame • Plugged, leaky or rusted burner • Clean / replace burner
Warming rack does not fit • Legs are angled too narrowly, or too widely • The warming rack feet are adjustable. Bend them to fit into
the warming rack holes.
TROUBLESHOOTING GUIDE FOR ELECTRIC IGNITION
Problem Probable cause Solution
No sparks when pressing the ignition;
no sound • Battery not installed correctly
• Empty battery
• Ignition button not installed correctly
• Defective spark generator
• Install battery (ensure that Ò+Ó and Ò-Ó are oriented cor-
rectly, with Ò+Ó at the top and Ò-Ó at the bottom)
• Replace with new AA battery
• Screw off button and reinstall
• Replace spark generator
No sparks when pressing the ignition;
sound is present • Faulty ground • Remove and reconnect all connections with spark generator
and electrodes
Sparks are present but not with all elec-
trodes and/or not powerful enough • Faulty ground
• Spark flashover away from burner(s)
• Low battery
• Electrodes are wet
• Electrodes cracked or brokenn “sparks are present”
• Remove and reconnect all connections to the spark genera-
tor and the electrodes
• If sparks are present that do not originate from the
burner(s), the wiring may be damaged. Replace the wiring.
• Replace with new AA battery
• Use paper tissues to remove the dirt
• Replace cracked or defective electrodes
785%2+($7,1*6<67(0
$QDGGLWLRQDOIHDWXUHLVWKHQHDWLQJ6\VWHP\RXU
EDUEHFRRNLVLPPHGLDWHO\UHDG\WRJULOODQGWKHKHDWLVGLVWUL
EXWHGRSWLPDOO\ $GYDQWDJHEDUEHFRRNXVHVOHVVJDVWKDQDQ\RWKHUJDV
EDUEHFXH
'(
HANDBUCH FÜR MONTA G E,
BETRIEB UND WARTUN G
6,&+(5+(,76,1)250$7,21(1
',(6(6*(5b7,67$866&+/,(66/,&+
)h5'(1%(75,(%,0)5(,(1%(
67,007%(,*$6*(58&+
'5(+(16,(',(*$6=8)8+5$%
/g6&+(16,((9(178(//(
)/$00(1
g))1(16,('(1'(&.(/
58)(16,(819(5=h*/,&+,+
-
5(1*$69(5625*(52'(5',(
)(85:(+5$1:(11'(5*$6
-
*(58&+1,&+79(56&+:,1'(1
62//7(
‡ '(5%(187=(5,67)h5',(25' -
181*6*(0b66(0217$*(81'
6$&+*(0b66(9(5:(1'81*',(
-
6(6*5,//69(5$17:257/,&+
‡ ',(1,&+7(,1+$/781*'(5$1:(, -
681*(1',(6(6+$1'%8&+6.$11
=8)(8(581'(;3/26,216*(
-
)$+5)h+5(1
‡ ',(1,&+7(,1+$/781*'(5$1:(, -
681*(1',(6(6+$1'%8&+6.$11
=86&+:(5(19(5/(7=81*(181'
6$&+6&+b'(1)h+5(1
‡ 75$*(16,(%(,080*$1*0,7
%(621'(56+(,66(17(,/(167(76
6&+h7=(1'(+$1'6&+8+(
‡ b1'(581*(1$0*5,//6,1'*( -
)b+5/,&+81'1,&+7=8/b66,*
',(6(6*(5b70866*(0b66'(1
*(/7(1'(1%(67,0081*(1,16
-
7$//,(57:(5'(1
‡ /$*(516,(',(*$6)/$6&+($86 -
6(5+$/%'(6+$86(6$1(,1(0
*87%(/h)7(7(1257$8)
‡ %(:$+5(16,(',(5(6(59()/$ -
6&+(92//2'(5/((51,(0$/6
817(52'(51(%(1(,1(0*5,//
$8)'(5*(5$'(9(5:(1'(7
:,5'
‡ /$*(512'(59(5:(1'(16,(
.(,1%(1=,12'(5$1'(5((17 -
)/$00%$5(1'b03)(81')/h6 -
6,*.(,7(1,1'(51b+(',(6(6
2'(5,5*(1'(,1(6$1'(5(1
*5,//6$8)
‡ 67(//(16,(6,&+(5'$666,&+
%5(11%$5(60$7(5,$/0,1'(6 -
7(16&0920*5,//(17)(517
%(),1'(7
‡ +$/7(16,('(15$80581'80
'(1*5,//67(76921',9(56(1
%5(11%$5(10$7(5,$/,(1%(1=,1