www.barbecook.com
14
11.4 Maintaining enamel, stainless steel,
chrome and powder coated parts
The appliance is composed of enamelled, stainless steel, chromed and
Material
How to maintain this material
Enamel
•
Do not use sharp objects and do not
knock against a hard surface.
•
Avoid contact with cold liquids while
still hot.
•
You can use metal sponges and
abrasive detergents.
Stainless steel
and chrome
•
Do not use aggressive, abrasive or metal
detergents.
•
Use soft detergents and let them act on
the steel.
•
Use a soft sponge or cloth.
•
Rinse thoroughly after cleaning and dry
well before storing.
Powder coated
•
Do not use sharp objects. Use soft
detergents and a soft sponge or cloth.
•
Rinse thoroughly after cleaning and dry
well before storing.
To prevent formation of rust on stainless steel, avoid contact
with chlorine, salt and iron. We recommend not using the
appliance near the coast, near railways or near swimming
pools.
Damages caused by not following these instructions are
regarded as inadequate maintenance and are not covered by
the warranty.
Below the exploded view of your appliance (second part of the
manual), you find a list with all parts of which the appliance is
composed. This list includes a symbol that specifies the material of
each part, so you can use it to check how you have to maintain a
particular part. The parts list uses the following symbols:
Symbol
Material
Enamel
Chrome
Stainless steel
Powder coated
11.5 Storing the appliance
If you do not use your appliance for a longer period of time, store it in a
dry place. Before you store the appliance:
•
Disconnect the gas cylinder. Never store your appliance indoors
(not even in a garage or shed) as long as it is connected to the gas
cylinder.
•
Clean the burners and the grills, rub them with oil and wrap them
in paper.
•
Cover your appliance with a Barbecook cover. Register your
appliance at www.barbecook.com to find out which cover you
need.
11.6 Storing gas cylinders
These instructions apply to both empty and full gas cylinders.
•
Always store gas cylinders outdoors, in a well-ventilated area.
Make sure they are not exposed to excessive heat or direct
sunlight.
•
Never store a gas cylinder in an area that can become very hot (in
a car, on a boat...).
•
Never store your gas cylinder or spare gas cylinder in the cabinet
of your appliance.
•
Never store your spare gas cylinder near a gas appliance in use.
•
Always store gas cylinders outside the reach of children.
•
Always store and transport gas cylinders in upright position.
11.7 Ordering spare parts
Parts that are directly exposed to fire or intense heat have to be
replaced from time to time. To order a spare part:
1.
Look up the reference number of the part you need. You find a list
of all reference numbers below the exploded views in the second
part of this manual and on www.barbecook.com.
If you registered your appliance online, you will automatically
be guided to the correct list.
2.
Order the spare part at your point of sale. You can order parts both
under and outside warranty.
12 WARRANTY
12.1 Covered
Your appliance comes with a warranty of two years, starting from the
date of purchase. This warranty covers all manufacturing defects,
provided that:
•
You used, assembled and maintained your appliance according
to the instructions in this manual. Damages caused by misuse,
incorrect assembly or inadequate maintenance are not regarded
as manufacturing defects.
•
You can present the receipt and the unique serial number of your
appliance. This serial number starts with a G, followed by 15 digits.
You can find it:
-
On this manual and on the starter pack that included the
manual.
-
On the packaging of the appliance.
-
On the inside of the bottom front panel.
•
The Barbecook quality department confirms that the parts are
defective and that they proved defective under normal use, correct
assembly and adequate maintenance.
If one of the above conditions is not met, you cannot claim any form
of contribution. In all cases, the warranty is limited to the repair or
replacement of the defective part(s).
12.2 Not covered
The following damages and defects are not covered by the warranty:
•
Normal wear and tear (rusting, distortion, discolouration...) of parts
that are directly exposed to fire or intense heat. It is normal to
replace these parts from time to time.
•
Visual irregularities that are inherent to the manufacturing process.
These irregularities are not regarded as manufacturing defects.
•
All damages caused by inadequate maintenance, incorrect
storage, improper assembly or modifications made to pre-
assembled parts.
•
All damages caused by misuse and abuse of the appliance (not
using it according to the instructions in this manual, using it for
commercial purposes...).
Содержание 223.9541.200
