barbas Unilux-7 45, Руководство по установке и обслуживанию

Страница: 30 / 52

4. Connect the flexible aluminum pipes (B) on the collar adaptors (A) . Use the hose
clamps ( C).
5. Connect the flexible aluminum pipes to fitting boxes in the fireplace enclosure.
6.3.6 Insulate the appliance
Caution:
• Use white unbound ceramic insulation wool. Do not use glass wool or rock
wool, these materials can cause a bad smell, unwanted smoke and is not
applicable for high temperatures. Refer to chapter
5.1
for the
specifications.
• Put a ceramic wool blanket with a thickness of at least 5 cm on the top of the
appliance and the sides and back of the appliance.
• Keep approximately 10 cm free of insulation material between the front of the
appliance and the front of the fireplace. This space is needed for the build of the
fireplace.
6.3.7 Build the fireplace
Important:
• Refer to chapter
5 for clearances to flammable and non-flammable
materials.
• Refer to chapter
5.1
for applicable insulating plates.
• Make sure that brickwork is build with a clearing of at least 3 mm between
the sides and top of the appliance and the brickwork. The appliance can
expand during operation due to heating.
Note:
• Make sure the thickness of any plastering is taken into account when
making the brickwork.
• Do not use masking tape on the appliance. Masking tape damages the
paint on the appliance.
• If you use other material than bricks, install the material in accordance with
the instructions of the supplier of the material
• If you use other material than bricks, refer to the instructions of the supplier
of the used material for information on the need to use a mantle iron.
Installation
30 Unilux-7 75