barbas UNILUX-6 40, Инструкция по установке и руководство по ежегодному обслуживанию

Страница: 23 / 44

23
UNILUX-6 40
Installation instructions
3.3.3 Fitting in an existing chimney
Do not use masking tape on the appliance when
installing and plastering.
Tape can damage the fi nish of the appliance.
• Remove the existing fi re basket or stoking stones and remove the shut-off fl ap.
The chimney must be intact and must not be damaged during fi tting.
The chimney breast opening must be big enough for a gap of 1 - 3 cm to be left all
round the appliance. Clad the chimney breast opening from the inside with a ceramic
wool fi reblanket or similar (see section 3.3).
• Extend the existing chimney so that it ends at the appliance’s smoke outlet. To do
this, use a fl exible, double-walled stainless steel chimney, for example.
• Slide the appliance into the chimney breast opening. Seal the smoke outlet where it
joins the chimney so that no soot can accumulate above the appliance
under any
circumstances . See 3.3.4.
• Level off the appliance so that the cover does not catch on the base.
• Fill any gaps around the appliance with a ceramic insulation wool fi reblanket and
position the frame (where supplied) .
3.3.4 Fitting in a newly-built chimney
Do not use masking tape on the appliance when
installing and plastering.
Tape can damage the fi nish of the appliance.
• Clad the appliance on the top, sides and rear up to the front edge with an approx.
10 cm thick ceramic isolation wool fi reblanket. Leave a few centimetres clearance
between the front of the chimney and the appliance.
• Level off the appliance.
• Make a good seal between the smoke outlet from the appliance to the chimney.
See also 3.3.5.
Ensure that the entire fl ue is gas-tight.