barbas Cuatro-7 75-60, Руководство по установке и обслуживанию

Страница: 47 / 76

10.5.8 Remove the vermiculite panels
Only do this procedure after finish of the procedure in section 10.5.7 .
1. Carefully put the end of a screwdriver
under a panel and lift it up.
2. Remove the vermiculite panel.
3. Do step 1. and 2. again for the other
vermiculite panels.
10.6 Installation of the interior of the combustion chamber
1. Install the vermiculite panels. Refer to section 10.6.1 .
2. Install the cast iron side panels. Refer to section 10.6.2 .
3. Install the steel bottom plates. Refer to section 10.6.3 .
4. Install the cast iron rear panels. Refer to section 10.6.4 .
5. Install the grate. Refer to section 10.6.5 .
6. Install the upper baffle. Refer to section 10.6.6 .
7. Install the lower baffle. Refer to section 10.6.7 .
8. Install the heat shield. Refer to section 10.6.8 .
10.6.1 Install the vermiculite panels
1. Put the top of the vermiculite panel in
the U-shaped holder in the appliance.
(1)
2. Move the vermiculite panel to a
vertical position. (2)
3. Lower the vermiculite panel. (3)
4. Repeat this procedure for the other
vermiculite panels.
1x
4x
1x
1x
1x
4x
Maintenance
Cuatro-7 75-60 47