v1 October 21, 2016
5
SETTE™ 270W MANUAL
®
OPERATION
BEFORE USING YOUR GRINDER
Prior to using your Sette grinder for the first time, you should wash the bean hopper and grounds bin in warm soapy water.
Do not wash the grind adjustment assembly or burr
. See the section on Care and Cleaning for instruction on how to remove
and reinstall these parts. There may be some rust on the burrs when you receive your grinder. This is normal and will
disappear after a small amount of coffee has been ground. To remove the rust and season the burrs, grind one handful of
coffee beans, on a coarse setting (#20), and discard.
INITIAL SETUP
Place the Sette on a level surface and plug the power cord into the back port on the machine. Plug the cord into a correct
voltage AC outlet only.
HOPPER INSTALLATION
With the hopper lid in place, mount the hopper by lining up the hopper’s bean shutoff knob at
the 11:00 position (back left). Press the hopper down, and rotate clockwise until the alignment
tabs on the front are aligned. Flip the bean shutoff knob to the “open” position and pour in
desired quantity of roasted, whole coffee beans.
ADJUSTING THE CONVERTIBLE DEVICE ARMS & PORTAFILTER HOOK:
The convertible device arms that hold the grounds bin can also be used to hold most
popular brewing devices such as V60, AeroPress, Clever, and Able Kone. To convert to
the portafilter holder position, push in on the right arm and swing it down and to the left
(fig. A). To return to original position, push in on the right arm and rotate to the right and
up (fig. B). The left arm will automatically move into position.
When grinding directly into a portafilter, you must first convert the arms to portafilter
holder position and swing the hook to the front. The hook is designed to support the
top lip of your portafilter while the arms support the bottom of your portafilter. It is
imperative that your hook is adjusted so that your portafilter sits level. To adjust the
hook, loosen the 2mm hex screw that sits below the hook, adjust the portafilter hook
up or down, and tighten screw once in the proper position. After you have adjusted your
hook, run a test grind, if your portafilter does not sit level through the grinding process,
you may need to make further adjustments.
fig. A
fig. B
