Baoding Longer Precision Pump LEAD-2 Longer, Руководство по эксплуатации

Страница: 7 / 20

ID 0.5 INT
■
123.4mL/min
a.
c.
d.
b.
e.
▲
Running Interface
Display running interface after initialization.
3
4
ID 0.5 INT
■
90.5 rpm
b.
Flow Rate Display
Speed Display
Menu Frame Work
ID 0.5 INT
■
123.4mL/min
Running interface
1.Calibration
2. ystem Setting S
3.Control mode
4. xit
E
Act Vol 1234
：
μL
Press to exit
a.Tubing ID
0.5mm
：
b.Test time
0.5min
：
c.Remote
Control:on
d. ump I.D.#.
P
1
e.Footswitch
Gated
:
f. ack
B
Select
RPM Flow
Function Setting
ID 0.5 INT
■
123.4mL/min
In running interface, press the to enter the
calibration interface. Turn the to select 4
function setting interfaces.
Adjusting Knob
Adjusting Knob
Calibration Setting
Calibration is needed in below situations:
1.Use the pump the first time; 2. Change the pump head; 3.
Change the tubing; 4. Setting new flow rate; 5. Operating
condition changes.
ID 0.5 INT
■
123.4mL/min
Test time
0.5min
：
Cal Vol:
1234 μL
Press to begin
Enter calibration function setting interface:
Note:
In speed Display, the calibration function is forbidden. In Running
Interface, press the , it will display: Adjusting Knob
LEAD - 2 OPERATING MANUAL LEAD - 2 OPERATING MANUAL
1.Calibration
2. ystem Setting S
3.Control mode 4. xit
E
1.Calibration
a. Running direction.
b. Current flow rate and speed.
c. Tubing inner diameter. “ID0.5” means the inner diameter of the
tubing is 0.5 mm.
d. Start/Stop state: “Start” state displays “ ”, “Stop” state
displays “ ”.
Control mode: “INT” means the pump is controlled by internal
control; “shut” means remote control is in “off” state; “V” means
the pump is controlled by remote control analog voltage signal;
“mA” means the pump is controlled by remote control analog
current signal.
■
Running interface
To switch to “Speed Display”
please see page 9 “Control
Mode” for setting method
Press
the Knob
Turn the
Knob
Turn the
Knob
Turn the
Knob
Running interface
Press
the Knob Press
the Knob
Display the
next screen
automatically
after 2 seconds
To switch to “Speed Display”
please see page 9 “Control
Mode” for setting method
Press to exit
In RPM mode
Press the to exit. Adjusting Knob