5.
When the Motorized Bumper Boat™ is partially inflated, fully insert the pipe cover from the top. Finish inflating
the air chambers.
6.
NOTE: Fill inflatable with air until the inflatable is firm and solid. If any seam begins to strain, immediately stop
inflation and release air to reduce the pressure until all signs of stress on the inflatable are gone. DO NOT use
the item if there is straining at the seams. Use of an over inflated item can result in serious injury, paralysis or
death.
7. Insert the propeller unit into the pipe cover from underneath the Motorized Bumper Boat™. You will hear the
unit click into place when it is properly inserted.
8. Attach the controller unit to the top of the propeller pipe by aligning the connectors and pressing the unit down
until it clicks twice.
NOTE: If you do not hear 2 clicks, the controller unit is not properly attached to the propeller pipe.
For easier assembly, push at the positions shown.
2.
Setup Instructions
1.
I
Parts
3
and
4
are shipped together and must be separated before assembling this item.
II
Press the release latches (A) and push
3
downward while pulling up part
4
.
III
Separate pipe cover from propeller pipe.
2. Fully assemble before using this toy in a pool. Do not use on pavement or other hard surfaces.
3. Roll out Motorized Bumper Boat™. Inspect for holes, tears or other damage.
4. Inflate the Motorized Bumper Boat™ with air until it is halfway full. See diagram for air chamber locations.
NOTE: For easy air inflation, use a manual air pump designed specifically for plastic inflatable items.
1.
7.
6.
8.
Setup Instructions
5.
4.
I
III
II
3
4
A
3.
BANZAI 4
BANZAI 5