Bante821 Portable Dissolved Oxygen Meter
5
Connecting the Sensor
Insert the 6-pin connector of the dissolved oxygen probe into the corresponding connector socket on meter. Ensure the connector is fully seated. After
connection is completed, DO NOT pull on the sensor cord. Always make sure that the connector is clean and dry.
Switching the Meter On and Off
•
Press the
Meas
key to switch on the meter, the display shows the measured value.
•
Press and hold the
Meas
key for 5 seconds, the meter will switch off.
To enable the Auto-Power Off feature, please refer to chapter SETUP MENU.
Prior to Use
•
Remove the protective cap from the bottom of the probe.
•
Switch on the meter 10 to 15 minutes and wait for the probe to polarize.
