SureCross
®
Quick Start Guide for DX80SRxM-H Serial Data Radios
Step 2 - Configure the Serial Data Radios’ DIP Switches
1. To access the DIP switches, remove the four screws on the cover and lift the cover off the radio base.
2. Unplug the ribbon cable from under the radio cover.
3. With the radio top facing up, gently tap the radio top on the table. The black plastic cover should fall out, revealing the DIP
switches.
4. Configure one radio to be the master radio (Master Routed mode: 6 and 8 ON).
5. Configure the second radio to be a slave radio (Slave Routed mode: 6 and 7 ON).
6. Set DIP switches 1 through 5 according to your baud rate and parity on both the master and slave radios. Refer to the Serial
Data Radio datasheet for DIP switch settings.
Slave radio with DIP switches 6 and 7 in the
ON position.
Master radio with DIP switches 6 and 8 in the
ON position.
Step 3 - Connect the Serial Data Radios to the Devices
Replace the serial cable with the Serial Data Radios.
1. Connect the master serial data radio to the notebook computer.
2. Connect the slave serial data radio to the Gateway.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
