Figure 17. Side-Mount Bracket
EZLSA-MBK-16
Side Mount Bracket
• See
Mounting the Center- and Side-Mount Brackets
on page 30 for the general mounting procedure.
• See
Sensor Mounting and Mechanical Alignment
on
page 31 for additional mounting
recommendations.
• The machine interface connector ends of both
sensors must point in the same direction.
• The sensors are designed to be mounted with up to
910 mm of unsupported distance between brackets
when they are subject to shock or vibration.
• See
mounting bracket dimensions and the installation
guide.
5.2.5 Sensor Mounting and Mechanical Alignment
Verify that:
• The emitter and receiver are directly opposite
each other
• Nothing is interrupting the defined area
• The defined area is the same distance from a
common reference plane for each sensor
• The emitter and receiver are in the same plane
and are level/plumb and square to each other
(vertical, horizontal, or inclined at the same
angle, and not tilted front-to-back or side-to-
side)
Figure 18. Incorrect Sensor Alignment
Level Surface
X
X
Emitter
Receiver
level
level
Y
Y
Z
Z
Level Surface
A
B
level
level
X
X
EZ-SCREEN
®
LS Basic Safety Light Screen
www.bannerengineering.com - Tel: 763.544.3164
31
