Banner Q5Z, Инструкция по эксплуатации

Страница: 19 / 41

June 23, 2023
Q5Z Global Laser Measurement Sensor With IO-Link Instruction Manual
19
Chapter Contents
6.1 Two-Point Static Background Suppression ................................................................................................................................................. 19
6.2 Dynamic Background Suppression ............................................................................................................................................................. 20
6.3 One-Point Window (Foreground Suppression) ........................................................................................................................................... 21
6.4 One-Point Background Suppression ........................................................................................................................................................... 23
6.5 Dual (Int Distance) .......................................................................................................................................................................... 24
Use the following procedures to teach the sensor.
Channel 2 can be taught only if the sensor has been configured for channel 2 to be light operate or dark operate. To change
the active channel, press the TEACH five times. The LED indicator of the now­activated channel flashes five times and can
be taught normally. The teach method of both channels is the same.
NOTE: If the TEACH procedure is in process, it can be canceled by pressing the TEACH button for longer
than 2 seconds or by holding the remote input high for longer than 2 seconds.
Two­point TEACH sets a single switch point. The sensor sets the switch point between two taught target distances, relative
to the shifted origin location.
1
4
2 3 5
TEACH Procedures
Chapter 6
Two-Point Static Background Suppression
6.1
Two-Point Static Background Suppression (Light Operate shown)
Figure 18.
Present the target.
Method Action Result
Push Button
Present the first target. The sensor-to-target distance must be within the
sensor's range.
Remote Input
1.
Start the TEACH mode.
Method Action Result
Push Button Press and hold TEACH for longer than 2 seconds. The indicator of the active channel flashes.
Remote Input No action required. N/A
2.
Teach the sensor. 3.
© Banner Engineering Corp.