Screw-On Mounting Bracket
(Screws to Alignment Tool; Screws onto
SFP12/30 Safety Point Housing)
SFP12
SFP30
Figure 1. Screw-On Mounting Bracket
REMOVE TWO PHILLIP
S SCREWS
FO
R BA
TTER
Y ACCESS
BELOW
DO NOT ST
AR
E INT
O BEAM. CLA
SS 2 LASER P
RODUCT
.
AVOID EXPOSURE
- LASER
LIGHT
EMITTED FROM THIS APERTURE
REQ
UIRES ONE 9V BA
TTER
Y
LASER
LIGHT
LAT - 1
Peak Power:
2.8 mW
, 640-660nm
33kHz 25% duty cycle
COMPLIES WITH 21 CFR
PART
1040.10
AND
EN60825-1; 1994
Emitter
Centerline
40 mm
(1.6")
21 mm
(0.8")
75 mm
(3.0")
75 mm
(3.0")
ON/OFF Switch
Snap-On Mounting Bracket
(Screws to Alignment Tool;
Snaps onto Light Screen Emitter or Receiver)
Circular Bubble
Level
Figure 2. Dimensions
Specifications
Supply Voltage and Current
One standard 9V battery, included (replaceable); ap-
proximately 20 hours of continuous operation
Construction
Aluminum housing; black anodized finish
Black polypropylene cover with flexible hinge for bat-
tery access
Environmental Rating
NEMA 1; IEC IP50
Operating Conditions
Temperature: 0° to +40°C (+32° to 104°F)
Maximum Relative Humidity: 90% @ +50°C (non-con-
densing)
Application Notes
See Caution on page 1 regarding safe use of laser
beam.
Sensing Beam
Class 2 laser, 640-660 nm visible red IEC
Pulse Width: 7 μs
Rep rate: 30 μs
Peak output power: 2.8 mW, 33kHz, 25% duty cycle
Beam Size at Aperture
Approximately 2 mm (0.08”) diameter
Beam Divergence
± 1.0 milliradian within specified temperature range
± 0.5 milliradians at room temperature
Beam Placement
Within ± 4 milliradians (approximately ±0.25 degrees)
of parallel to front, back, top and bottom of housing
Laser Classification
U.S. Safety Standards 21 CFR 1040.10
European Standards EN 60825-1:1994
LAT-1-x Laser Alignment Tool
2
www.bannerengineering.com - tel: 763-544-3164
P/N 054599 Rev. E
