June 22, 2023
page
4
K30 Pro Optical Sensor Quick Start Guide
Specifications
Supply Voltage (Vcc)
10 V DC to 30 V DC
Supply Current
110 mA maximum current at 30 V DC (exclusive of load)
30 mA typical current at 24 V DC (exclusive of load)
Supply Protection Circuitry
Protected against output short-circuit
Leakage Current Immunity
400 µA
Range
The sensor can detect an object at the following ranges, de
pending on the material and size of the target: 20 mm to 1000
mm
Output Ratings
Maximum Load
: 150 mA
ON-State Saturation Voltage:
< 2 V DC at 10 mA
< 2.5 V DC at 150 mA
OFF-State Leakage Current: < 10 µA at 30 V DC
Remote Input
Allowable Input Voltage Range: 0 to Vsupply
Active High (internal weak pull-down): High state > (Vsupply -
2.25 V) at 2 mA maximum
Active Low (internal weak pull-up): Low state < 2.25 V at 2 mA
maximum
Mounting
M22 × 1.5 threaded base, maximum torque 4.5 N·m (40
in·lbf)
Construction
Base, Dome, and Nut: Polycarbonate
Connections
Integral 5-pin or 8-pin M12 male quick-disconnect connector
Models with a quick disconnect require a mating cordset
NOTE: A shielded cable is required if the
sensor is mounted outdoors or if the ca
ble is longer than 30 m (98.4 ft).
Vibration and Mechanical Shock
All models meet MIL-STD-202F, Method 201A (Vibration: 10
Hz to 60 Hz maximum, 0.06 inch (1.52 mm) double amplitude,
10G acceleration) requirements.
Method 213B conditions
H&I.
Shock: 75G with device operating; 100G for nonopera
tion
Operating Temperature
–20 °C to +50 °C (–4 °F to +122 °F)
Storage Temperature
–40 °C to +70 °C (–40 °F to +158 °F)
Sensing Beam
Infrared, 940 nm
Delay at Powerup
< 1 s
Response Time
Switching frequency: 4 Hz
Discrete output response: 120 ms
Remote Input Map
0.04 seconds < T < 0.8 seconds
Timing between pulse less than 1 second
Pulse Timing (T)
Gray/Yellow wire is remote teach input
Remote
Input
3x
Object Mode Teach
1x
Confirm Teach
4x
Background Mode Teach
1x
Confirm Teach
5x
Window Mode Teach
1x
Confirm Teach
7x
Enable/Disable Remote Teach
1x
Confirm Enable/Disable
9x
Reset to Factory Defaults
1x
Confirm Factory Reset
© Banner Engineering Corp.
