4
© Banner Engineering Corp. www.bannerengineering.com
K30 P
RO
O
PTICAL
S
ENSOR
I
NSTRUCTION
M
ANUAL
B
ANNER
E
NGINEERING
C
ORP
.
Figure 7:
Remote Input Map
Teach Modes and Operation
Object Mode (default)
Teach Status Color: Blue
The K30 Pro Optical Sensor is configured to Object Mode by default. Object Mode sets the total Detection Area from the sensor to the Set Point plus the Offset Value
(50 mm default). Use Object Mode to trigger a change in state when an object is present between the sensor minimum (20 mm default) and the taught distance plus
the offset.
Three-pulse the remote input to enable Object Mode. Successfully entering Object Mode causes the device to alternate between the Teach Status color (Blue) and
the Signal Level color.
Background Mode
Teach Status Color: Magenta
Background Mode sets the total Detection Area from the sensor to the Set Point minus the Offset Value (50 mm default). Use Background Mode when there is a
constant background object present and a state change is desired when another object is in front of that background.
Four-pulse the remote input to enable Background Mode. Successfully entering Background Mode causes the device to alternate between the Teach Status color
(Magenta) and the Signal Level color.
0.04 seconds < T < 0.8 seconds
Timing between pulse less than 1 second
Pulse Timing (T)
Gray/Yellow wire is remote teach input
Remote
Input
3x
Object Mode Teach
1x
Confirm Teach
4x
Background Mode Teach
1x
Confirm Teach
5x
Window Mode Teach
1x
Confirm Teach
7x
Enable/Disable Remote Teach
1x
Confirm Enable/Disable
9x
Reset to Factory Defaults
1x
Confirm Factory Reset
Detection Area
Switch Point (D2)
Set Point
+50 mm
(Offset Value)
